Recent content by jayramble

  1. jayramble

    What Did You Do for Your Van Today?

    Check under this post - towards the bottom - Post in thread 'Single din radio trim' https://delicaforum.com/index.php?threads/single-din-radio-trim.5319/post-43446
  2. jayramble

    Mitsubishi is still producing a version of the L300 in the Philippines

    Will respond on pm but to answer your question about conversion to LHD, the dash is the biggest concern along with the steering rack but good news is plenty of second hand LHD dash available as well as new steering racks then it is a matter of finding a good mechanic- I have been training mine...
  3. jayramble

    Mitsubishi is still producing a version of the L300 in the Philippines

    The new L300 versions are produced as a 2WD commercial version with L300 Delica 4WD passenger models usually converted to LHD from Japanese RHD imports from models produced back in the 90’s. But as the commercial version is still produced many new parts are commonly available although these...
  4. jayramble

    What Did You Do for Your Van Today?

    My LHD conversion 1993 Starwagon is still in the mechanics have some more work done, list so far is: New KYB front shocks - Premium level as unable to easily and quickly obtain Bilstein's, etc. here in Manila. Complete / all ball joints in the front end as many rubbers had perished Dash...
  5. jayramble

    What Did You Do for Your Van Today?

    Preparing for a road trip up north several hours past Manila; previously replaced brake pads and shoes plus rotators and other brake parts, along with alternator and conversion of AC compressor to the new gas as well as inserted LED bulbs in the Delica rear door logo trim and added LED...
  6. jayramble

    Delica 1991 Power window switch

    Has anyone rewired the LHD new switch for a RHD, assume has to reposition the plug wires as when I connect my right hand window automatically lowers - any suggestions for rewiring?
  7. jayramble

    newbie

    Welcome, will you share your location and a photo of your Delica ?
  8. jayramble

    A/T Temp Light Won't Go Away

    Replaced last post with this - I discovered air pocket(s) in my new cooling system after installing a new radiator and coolant temp sensor, after doing my best to reduce/eliminate the air pockets over several days and topping up the coolant each morning, the ATF temp light would disappear until...
  9. jayramble

    Beach camping in the Philippines

    Do you have photos of your setup?
  10. jayramble

    Right hand to Left hand drive conversion

    Here in the Philippines are plenty of LHD drive conversions, maybe better to purchase one here for your trip and then resell, there are plenty available here - how long is your trip, maybe you can hire one
  11. jayramble

    4wd light flickers

    Great news (for me and my OCD) - 4WD Indicator light working - Yes it was wires, but not the switches/sensors, rather as these looked newish I traced the wires across the top of the transfer case to the sliding door side and found a brittle wire which snapped in my hand; with a solder, shrink...
  12. jayramble

    4wd light flickers

    Thanks for sharing, I have another mini project haha
  13. jayramble

    How to get under the drivers seat

    Is the seat adjuster installed on both front bucket seats or only the driver? If only driver can they be installed on the passenger bucket seat? I ask as I have a LHD conversion here in Manila, thus the passenger seat is in front of the air filter, and its a PITA to remove and assume a seat...
  14. jayramble

    trying to identify a part on the transfer case

    Being OCD, as mine don't work I checked and my wires are connected, yet I am sure they used too, checked the blubs in the cluster and appear all good and swapped the 4wd indicator bulb with a known working one but still no illumination, and the auto hub light is also not working so I will trace...
  15. jayramble

    l300 idle and engine temp

    Thanks for the suggestions on how to smooth the idle, something I will do later this week, and I changed my clurter bulbs to LEDs and way brighter - especially the blown bulbs haha
Top