Thomascrom
Member
Hello friend, thank you very much, no, I don't have that tool, what other way can I check if I have a leak? I am going to change all the vacuum hoses that the vehicle has to see if I can detect the fault. Another question I wanted to ask you is, where should I clean and grease the actuator? Sorry but I don't know where it is located, I guess it's in the rubber boot underneath where one of the hoses enters, correct me if I'm wrongIf you changed the solenoids then this behaviors suggests a vacuum leak somewhere, or a sticky actuator. They need cleaned and greased and it probably never has been so it might be that or a cracked vacuum hose somewhere. Finally vacuum pump might be weak? Not sure. If you have a vacuum brake bleeder tool then try putting a vacuum on the actuator lines and see if you can reliably get the flashing to be off.