Search results

Hey all, since I have the IP exposed I figured I should ask this question. If I apply slight pressure with my finger to the IP front shaft I can hear air trying to escape or enter from the seal area. I first noticed this when I did my timing belt putting pressure on the sprocket to adjust the...

So much work on my new van, belts, front oil seals and it repays me with a nice oil leak. Leaving several drops after I park running down the left bar next to the oil pan. Remind me why I got another L300? :) It seems to be dripping down from the AC compressor. I park on a slight incline...

I’ll make it home but the van has developed a bad shake going from a stand still till I get up to about 60km/hr then smooths out. The steering wheel has a visible vibration upon accelerating ands it’s very disconcerting. Cruising on the highway is just fine. It’s an automatic 4d56 engine...

Looks like a possibility fix for my worn out transmission mounts. https://www.energysuspensionparts.com/diymmi

Hey All I recently replaced my timing and balancer belt so I wasn't sure if this sound has something to do with that or an exhaust leak?. I have some oil leaking from the upper engine (exhaust manifold side) so I think it could be the gasket making some noise. Please see the video, this only...

Hey all its not serious but lately I'm not getting a first glow plug click until about 20 seconds after I turn key to "ON". I do get a 2nd click shortly after and the van starts just fine. Rewind a week or so and it was instantaneous when I turned key to ON. I always thought the first click...

Left rear run channel rubber part number MB478209 apparently for (if fitted, LHD Mitsubishi Van/Wagon for instance). (thanks for clarification Growlerbearnz!) Asking 50.00 (cad) plus shipping. Thanks.

Hey all I've been chasing a central lock issue with the passenger and rear sliding door not wanting to open up from the drivers side. They will close electronically but only after I've manually unlocked them both. I can hear the subtle "click" of the microswitch on drivers door when I try to...

Hey guys, I just did the timing belt today and it started up fine after the change. But its spitting out grey smoke when I rev the engine instead of the light puffs of black smoke like it did before the belt change. Yes all 3 timing marks line up perfect and my valve clearance is good if that...

Hi all, long time Delica.ca member (North54) and proud owner of now 2 1989 L300's. Managed to snag a nice low mileage (80,000km) 89' L300 a few days ago. It's been sitting for a couple years so I'm doing the usual maintenance to get it up and running top shape. Engine ticks like a fine swiss...

Hey all, nice to see many familiar names from the Delica.ca website on this forum! I've been an owner of an 89' P35W for the last 10 years. Alas old rusty is getting on with age/rust and I've managed to acquire another 89' so I'm trying to get the new one running better. Heres the first...