Search results

Thank you, I guess that's better than what I thought the leak was coming from earlier in my troubleshooting. rear main seal or transmission seal.

A fair amount of diesel fuel is leaking somewhere below the head gasket. The injectors are dry. Top of the engine is dry.??

What is recommended fluid for 1996 l 400 power steering fluid

I can get the information to you tomorrow, thank you

Hello again, Can anyone direct me where to purchase a rear main seal for a 96 delica L 400 4m40

Thank you all for the information. Very helpful

I did a bit of research, I believe your correct, rear main seal seams Luke the culprit, I don't have an oil pressure guage on my rig, I have about 90 k miles on it.

Is the main seal at the shaft output? That's dry. Or is the main seal between the engine and bell housing.

The drips I see are at the bell housing below the valve cover. I wiped the area dry as I could and saw a drip forming at the bell housing. I tried to tighten the bolts but all were tight. There t

G g

The drips I se are at the bell housing below the valve cover. I wiped the area dry as I could and saw a drip forming at the bell housing. I tried to tighten the bolts but all were tight.

Hello I was replacing my steering tie rod boots and noticed oil drops on passenger side of bell housing to engine.is this a big job? What has to be done?

Good fit up, reasonable price

I just put the bolts back in after removing the mirror, maybe a dab of silicone on the bolts.

Yes Scott, it's the diesel, if it's the sensor is that part replaceable and available?

Thanks for the reply Scott, What would your thoughts be on my issue. Sometimes it's working, and I've noticed when it's working the needle bounces between the actual rps and 0

L400 1996 is it cable actuated?

Hello, I'm located in so. Cal. In two weeks I'll be in Colorado for the summer. The bumper is missing a couple of pieces which I made patterns of, that any shop could duplicate. 500.00 for the kit.