Search results

Thank you. I'll give it a try and order a replacement screw

How does it come off? I don't see a mounting screw and it doesn't look like a set screw. Is it like the windshield wiper and just pulls off?

I've got stuff in the abcm so can't pull the panels, but this is a quick look at the outside. The drain plug is on each side, right below the corner access panels. Mounted where one of the bumper covers already screws in.

What was your final setup? I'm looking to install an oil pressure and temp gauge as well.

After years of staring at -26, I replaced the cabin temperature sensor. Big thanks to Delica USA for giving me the industry part number to the sensor. Spent like $9 in shipping for a $1 part, but it's done, haha.

Hah, if they ever come online (and I if win the lottery) I'll pick one up and give y'all a full review.

Lol, I was just about to share that same link.

Do I need to replace the whole thing, from the bracket down? Or is there a way to replace just the mirror?

Local Delica Club had a member parting out one that is headed for scrap.

It was the rear blower motor causing this whole mess. Was able to replace just the motor thank god.

Any tips? Mine is wide, by like a half inch. I'm wondering what I'm damaging driving it home from the auto hobby shop without a sway bar.

I have a couple missing. At least one is because the plastic is cracked. I found something similar at the local hardware store I think I can make work.

I'm looking for the metal clips that slide onto plastic components where the screws go, like around the dash. I'm looking at the parts diagrams and I was hoping they would all be the same, but that doesn't seem to be the case. Am I missing something or all they all really different? The screws...

Shot you a message.

Installed new leaf springs and rear shocks from Delicaworks. Pretty big difference even on the ground.

I'll gladly take it off your hands, you mentioned in the other thread about modifying for cup holders?

Do you still have this?

I pulled off a rear blower assembly in hopes of maybe finally fixing this short problem. Two questions: 1) What is a good material to replace the dried out weather seals? Just like a regular foam with adhesive back? 2) Any best practices to clean this out? Or should I just take the blower...

Looks better than anything I could hope to do. I was hopping to have it a bit more accessible. I'll keep playing around with where to put it in the cab.

I'll keep this in mind for the future. I've already bought the components for this iteration. Decided I'll build a box and mount it in the space in the center of the cab, below the radio. Not 100% sure how I'll mount it just yet.