Search results

Building my girl (1991 L300) into a camper setup. Sending curtains and the rear floor mats to a good home. Yours for the price of shipping and some beer (you decide how much is fair). Located in Boise Idaho

I'm getting set to replace my left (passenger's) CV axle. I had both replaced by a shop a year ago and they put in the wrong part so 4x4 hasn't been engaging. My girl is a 1991 P25W MT with manual hubs. Still not 100% which will fit so I ordered a Duralast 7901N and a MI-8106. Going to just to...

Pulled the original radiator from my Manual L300 P25W and replaced it with an aluminum radiator. The radiator works fine and appears to be in good shape. Does not come with cap. I just wanted to try the alleged added cooling power of the aluminum radiator. I can see some rust in the openings. I...

A few days ago I was pulled over because my bike rack (Yakima full swing) blocks my license plate. I'm going to keep the bike rack on there. Has anyone run into this before and come up with alternative ways to mount the rear license plate? I'd like to avoid just drilling it into the hatch if I can

Ordered new inner and outer tie rods from Rising Sun and am looking to install them myself here in the next week. Doesn’t seem like too difficult of a job, just wanted to check that it’s fairly straight forward. Does anyone know if I’ll need to get the special tie rod tool from Napa or Oreilly’s...

A belated hello to everyone, I’ve been the proud owner of a ‘91 L300 since December. Purchased in Bellingham, road tripped through the southwest for much of the winter then drove her up the Alcan to Fairbanks Alaska at the end of March. She’s still chugging along, so far I’ve put more than...