Troubleshooting loss of power at upper RPM

Can someone take a picture and circle where these inlet/outlet banjo bolts are on the injection pump? I can't seem to find them and I don't wanna start messing with things on a van that still runs fine.
 
sk66 said:
Inlet banjo goes where the copper washer/banjo bolt are in this pic.


Outlet banjo is shown in this pic (capped off)
Click to expand...
Thanks sk66! The inlet screen was moderately clogged with little fibers and gunk, but I don't think enough to really cause problems. I'm trying to figure out my intermittent rough/low idle problem. Air seems to be getting into the fuel system some how. When I bleed my lines the van will run smooth for a couple hundred miles and then I'll have to bleed it again. I've replaced the fuel filter and I use a fuel additive (Hot Shot's Secret Everyday (stuff is like crack...in a good way). I've bled the injectors. So at this point, I think it might be the IP gaskets, or fuel leaky lines. Additionally, my A/C idle up wasn't working and I adjusted the linkage, but my engine is very unhappy with the A/C on and it seems to make the rough idle and low rpms worse. Any thoughts?
 
are there any pics out there of where these banjo bolts are located? This is my first Delica started having the same loss of power issues. I ordered a new fuel filter and water separator but will want to check these screens out also....thanks
 
You must log in or register to reply here.
Top