Recent content by PhilipJ

  1. PhilipJ

    Steps to change Alternator on diesel L300 Delica?

    Hi Y'all! Pinging this thread with some issues. I had some serious squeaking and vibrations after getting my van back from the shop where a new OD solenoid was installed along with some transmission fluid change. They said the fan belt was very loose so they tightened it. Turns out the...
  2. PhilipJ

    Kickdown cable adjustment: a conversation with @prayforsurf

    Hey y’all! Pinging this thread and also commented on @Oki-Hai post: https://delicaforum.com/index.php?threads/delica-l300-automatic-transmission-shifting-issues.4870/ Having issues getting out of 3rd into 4th and I suspect it’s the linkage, kick down cable. Jumping up to High rpm then backing...
  3. PhilipJ

    Delica L300 Automatic Transmission Shifting Issues

    Hi y’all! Experiencing similar issues. Any help or instructions on adjusting the linkage, kick down cable? Note: previously it was getting into 4th after increasing rpms past 3500 but it was not smooth. Not sure if this is connected but the issue arose when switching overdrive off. Here’s...
  4. PhilipJ

    Automatic transmission won’t stay in 4th gear

    Hi y’all! Pinging this thread with a similar issue. For context, just had the engine tuned with EGT gauge installed. Recently had ATF changed with Lucas and took a trip to mammoth mountain (elevation 9,000). On the incline had the overdrive off and was slowed to around 65 kmph with 1200 on the...
  5. PhilipJ

    L300 automatic transmission filter and gasket

    Hey team! Pinging this thread to find a pan gasket part number. Would like to find something local.
  6. PhilipJ

    The L300 Suspension Thread

    Hi Steven, what are you selling the OEM for? email: philipjankoski@gmail.com
  7. PhilipJ

    The L300 Suspension Thread

    This is L300 right? Do you happen to have the Camber/Caster bolt/washer part numbers?
  8. PhilipJ

    Brake & Suspension Project Parts List

    Do you have the CTR part number? Did you replace the outers at the same time? Thanks!
  9. PhilipJ

    Brake & Suspension Project Parts List

    Thanks! I'll see if I can find that thread
  10. PhilipJ

    Brake & Suspension Project Parts List

    Hi Y'all, Pinging this thread. Looks like my driverside inner tie rod is loose and causing uneven wear. Should I replace all front Tie Rods and Tie Rod Ends or can I get away with just replacing the one loose inner Tie Rod? Also, is there a decent aftermarket part that could cut cost? I...
  11. PhilipJ

    LSD Differential Noise

    Parts question. Pretty sure I need to replace U joints ASAP. Rising Sun quoted around $250 for parts. Do you recommend going this route or could I go aftermarket with this repair? Coombs has AM for $160 out the door.
  12. PhilipJ

    Temperature Sensors

    Thanks, @sk66 went ahead and got the two-pronged sensor that matches with the OEM. Should be ok I hope!
  13. PhilipJ

    Which glow plug system is this?

    @Sputnik awesome, thanks. I searched EPC and pulled up MD092392. Didn't cross with anything on RockAuto.
  14. PhilipJ

    Which glow plug system is this?

    Hey @Gardenerguy I have the same aftermarket 12v relay for my 1992 L300 and manual switch. Do you have the Bosch part number by chance? How are they working out? Also considering, @dan NGK CY57 but having trouble finding a source and confirming they are 12V. Concerned about a previous comment...
  15. PhilipJ

    Temperature Sensors

    Hey guys, pinging this thread as the temperature gauge is not working on my Deli and thinking the sensors may need to get replaced. Anyone have a source or link to the parts where I can get them? Thanks in advance!
Top