Search results

How does it come off? I don't see a mounting screw and it doesn't look like a set screw. Is it like the windshield wiper and just pulls off?

Do I need to replace the whole thing, from the bracket down? Or is there a way to replace just the mirror?

Any tips? Mine is wide, by like a half inch. I'm wondering what I'm damaging driving it home from the auto hobby shop without a sway bar.

I'm guessing the subject is the issue. I pulled the van out of the garage for some cleaning and parked it up an incline, no issues. Wasn't running long at all, just long enough to move it. Then when I went to move it back, it just barely started, voltage looked to be under 12v on the gauge. I...

I've mounted some extra Backup lights that I want to tie into the stock lights and a bypass switch so I can use the solo. Ive go jumpers ran off the stock lights and dry hung the cables for testing.

I'm sure this won't be the only round throughout my re-wiring project. For reference, I have a '94 P35W. Below are two wires not presently connected to anything from the original after-market radio install. Green and white with red (or brown?) stripes. Black and red (or brown also?) with the...

I've started a project of re-doing all of the after-market accessory wiring with the help of a butane soldering iron, proper solder connectors, and shrink wrap. I was thinking about running a second fuse box to try and isolate a lot of these extras in case troubleshooting is needed later down...

Good Evening, Where is a good point inside the cab to tap into the reverse switch for head unit wiring purposes? I was thinking directly from the shifter, or where the shifter heads to the gauge cluster to illuminate the "R" lamp. I was looking at the wiring diagram PDF, but I am not sure what...

I've gone through posts back several years and it seems like there isn't a pre-built kit for a RHD L300. I do not the the equipment or skills to make my own. Is there an alternative to get Temps down when the engine is really working? There are times on the highway here in the summer when the...

Good Morning, Living on an island, rust is a constant threat. I've had my van repainted once and a lot of rust spots are starting to come back already after about two years. I've spoken to many people here and there is both a lack of truly high quality paint shops, no vinal wrap options, and...

Hello All, What is the best way to try and find the correct wiring diagram for a component in general? While I'm specifically looking for the 3 gage cluster, I'm a little confounded in general. I've found it in the service manual under instrument panel on both the interior chapter and the...

Has anyone used the Intercooler kit from T3 4x4 or have any other recommendations?

I've seen lists of people installing the Siberian Bushings. I was going to order some stuff from energy suspension but I'm not positive my measurements are correct. This is the universal I think has the right diameter but I think it is too wide for a '94 P35W...

Good Afternoon All, I saw some older posts from last year and before about this. Specifically about how there's some clearance concerns. Has anyone done this recently that can suggest a brand? Or is just searching for braided conversion kits sufficient? Thanks as always.

Good Morning All, A friend had installed a temp Gauge by Engine Watch Dog in his L400 as opposed to replacing a malfunctioning water temp Gauge. I was intrigued by their T4 one sensor that had a cooling fan relay that could be set to turn on the cooling fan at a give temp vice whatever the...

Good Morning All, I wasn't sure how to search the posts for this, might have already been answered. What is the part? Can't find it on the wiring diagram. It's in the steering wheel column. Thanks in advance.

Got in a little fender bender and I need a new front bumper. Been looking for weeks on Japan and Tawain eBay with little luck. Especially a replacement for the metal one I have. Are there aftermarket ones like the "ultimate" rear bumper out there?

Good Evening my Mechanical Mentors, It is a new year and that means a new accumulation of tax-deductible improvements to my Scuba Van. That being said, I don’t have the ability or time to spread this out over weeks/weekends/months so I’d like to do it all in one go. I’m making a parts list and...

Good morning everyone, hope you had a great weekend. I may or may not have broken one of my front rain/sun shields (I don't know what to call them). I looked on Amayama but couldn't find them. Are they an accessory instead? If they are they are installed damn well because they don't just pull...

Hello everyone. I'm trying to troubleshoot the rear blower of my '94 L300 out here in Japan. Neither the front or back switches have any effect. The only odd thing with the switches is on the front. If you press the switch the light turns on at the bottom of the press but it doesn't engage after...