Search results

Welcome! Post some pictures!

Is your van an automatic and a stock tune so far? Is there are reason you need a 7 pin connector as opposed to the standard one? Keep us posted on how it handles hills and if things change when its all loaded. Looking real good!!!

Welcome to the forum!

Welcome! We love pictures if you have any of Siberian Yacht!

if you open the drivers door and see an orange rectangular sticker on the door near the lower seal, then you have LSD

How much did this cost and how long did it take?

Tyler knows what he's doing. Good luck

amazon had the one i referenced above

you can verify this from underneath...crawl behind the front right wheel and look up and to the front with a flashlight you should see the half moon from here and you will see if its leaking...

can you verify its from the turbo? if you can upload any pics that might help. Often when replacing the valve cover gasket, leaks will form from the half moon.

There’s one screw that holds the horn in place and then the main 17mm hub bolt

yes that pic is the cam after the wpc treatment I used Colt Cams in BC I think it was less than 300 CAD what sort of performance numbers are you seeing with your setup now? this cam pulls real hard at around 2800. It ran quite a bit leaner and i had to stiffen the boost spring in the ip a...

Hi hive, Lately I have noticed my EGT gauge (analog) spikes like crazy then drops then spikes. It might be at 400, but it will spike to 1200, then back to 600, then higher and lower. It made me think the probe was bad. I got a new probe and it seems to do the same thing. It seems to settle down...

Mine had one of these on each side in the rear…no idea what they were for

I installed the 24mm bars and it greatly improved the ride

I’m looking for the rear bearing housing and backing plates for the rear axles - both sides.

I’m looking for the rear bearing housing and backing plates for the rear axles - both sides. Do you have these ?

I’m looking for the rear bearing housing and backing plates for the rear axles - both sides. Do you have these?

they fit on my 91

Hi Hive, The saga continues unfortuantely. I took the axles to a machine shop and they swapped out the bearings and retainers. I installed the axles as specified in the manual. 1mm shim on one side then measure the gap on the other and add 0.2mm shim to that. There was pretty much no gap at...