Search results

Hi hive, Lately I have noticed my EGT gauge (analog) spikes like crazy then drops then spikes. It might be at 400, but it will spike to 1200, then back to 600, then higher and lower. It made me think the probe was bad. I got a new probe and it seems to do the same thing. It seems to settle down...

I’m looking for the rear bearing housing and backing plates for the rear axles - both sides.

Hi hive, I’m getting a grinding noise from the rear. I removed the rear wheels and drum. When I spin the hub, I’m hearing it coming from the outer part of the axle where it meets the hub. It sounds like a wheel bearing but not entirely sure. Anyone replace rear wheel bearings before? How did...

Hi hive, Does anyone have any tips for getting the timing belt tensioner installed? I can muscle it on and load the spring but I can’t seem to get the belt on over the tensioner. Any guidance or tips would be most welcome

Hi hive if I pump my brakes …after several pumps, the dash brake warning indicator flickers on till I stop pumping then it goes out again. My fluid level looks ok… Do you know why this is? Do I need to look at my brakes for an issue? Thanks

After my rear DELICA light bar strip had a bulb die, I followed the installation guide thread where I swapped the bad standard bulbs for some green LED bulbs from amazon. I got a pack of 10 for under 12 USD. The light bar mod install called for just 2 bulbs and I have been pondering as to what...

Hi hive, What started as a quest to determine why my washer pump wasn’t working has turned into something more sinister. My brake lights do not work. I also have no e-brake engaged light. The bulbs are good and the 11 and 4 fuses are good (I swapped them anyway). This is an addition to my now...

Does anyone know which fuse is for the front washer pump? My washer pump isn’t working anymore and I can’t locate a fuse :/ Thanks

Hi hive Does anyone know the part number or bulb number/type for the GATE UNLOCK indicator in the dash? Thanks all

Hi hive, Do you know how to remove the middle screw for this sliding door panel?

Hi hive, My drivers door lock won’t lock with key. I cant press it down from inside the van either. My aftermarket keyless entry fob won’t do it either. I can see it move a little when I press the button, but I suspect something is jammed. Anyone have to fix this issue before? Any thoughts?

Hi hive Have any of you replaced the camshaft with a stronger grind aftermarket one? Whats involved in the swap? Where in the manual should i start looking? I have my old head w/cam that i can practice on

Hi hive Does anyone know the part number for the air conditioning idle up actuator? I’ve looked all over the microfiche sites but can’t fine it. Do other idle up actuators fit/work? Also what rpm should it be bringing my engine to when idling with the air conditioning running? Thanks

Hi hive - can you tell me where the oil seal goes on the dipstick tube? This is the 4d56 td motor

Hi hive, I did a 2 inch lift, 24mm torsion bars, Monroe air shocks, and stainless steel brake lines this weekend. Now my van seems to sag in the left rear. The darker picture from the rear is of it with the front wheels off the ground (torsion bars unloaded) and no air in the air shocks The...

Hi hive - what’s the best way to remove the dash clock?

hey guys..I just went to my local gas station and diesel is hovering around $6/gallon I went online and found what appears to be a company that makes kits to convert diesel vehicles to SVO/WVO/PPO Looks like they make "something" for a 4d56T...

Hello hive My front seat belts keep getting caught in the door. I slam the door and the buckle keeps getting chipped and cracked. Anyone else run into this? Any solution?

Hi hive - i know some of you guys are running meth injection kits and I am thinking of doing the same. I'm really just looking for another way to keep my EGTs down on long uphill grades. Any performance benefits would be gravy. For those of you who have seen my engine bay this is just another...

Hi guys I have a fuel filter heating pad that I have wrapped around my fuel filter housing. When I turned it on today I see faint whiffs of vapor/smoke wafting from it. I haven’t had any fuel leaks from the filter so I’m not sure what’s up. It’s possible that fuel spilled on it when I was...