Search results

I installed a boost gauge a few weeks ago. It is tee'd into the hose going to the IP. It works as expected. Boost has registered 9-10 psi max. I recently installed a Turbosmart manual boost controller. I put it inline with the hose going to the wastegate, with the arrow pointing toward the...

Saga begins with cooling system, timing belts, and oil seals in TX. See previous Post. I drove up to MN on easy highways and farm roads. Hit 70 a few times. My coolant temp gauge never went above half. Keeping EGT below 600C. On my way back to TX I headed west to SD and after a few days of...

I pulled the balance shaft seals and bushings to replace them. The upper shaft has about 0.2" (5mm) of end play (without seal, bushing,pulley,bolt). The lower balance shaft has no endplay. What is normal? Are here other specs I could check at this level of disassembly? I did the crank...

Long version... I was driving my L300 manual diesel back from a beach camping trip and the van overheated. I monitor the EGT and watch the coolant temp gauge pretty regularly so I got it on the side of the road pretty quickly. I was driving about 65mph on pretty flat highway and keeping the...

I'd like to replace the lower door seal (Red arrow) on my 93 L300. I thought this was the part, but when it arrived it is the lower seal on the car (blue arrow), not the door. I got Mitsubishi MB632587 - WEATHERSTRIP,FR DOOR,LWR LH Mitsubishi MB632588 - WEATHERSTRIP,FR DOOR,LWR RH Anyone...

https://bringatrailer.com/listing/1995-mitsubishi-delica-truck/ I didn't realize these were a thing. 6 hours left!

92' L300 4D56 MT I removed the left front axle to replace torn cv boots. What is this bronze spacer? it was on the wheel side of the axle inboard of the knuckle (red arrow in diagram). Is this the shim (#8) that is supposed to be under the snap ring? I did not have any shim there...

Hi all, I’m repairing my quarter side trim and rear side trim parts because they are all cracked. Does anyone know how to remove the lighter socket and cover plate from the panel? See photos...

Hi everyone, I need interior parts to replace my damaged/missing parts. I have a 93’ Exceed L300. I'm located in Austin, TX. Carpet: Need everything Trim: Rear hatch trim panel Rear left jack access panel Rear left armrest/speaker panel Rear right armrest/speaker panel latch for driver...