Search results

I gave the BISS a turn yesterday. And it moved the needle a tiny tiny bit. I’m not sure how many it would take to get the rpm’s up to a normal range.

I have. 1993 l300 4g64. I was having idle concerns a while back. I cleaned up the iac and throttle body. It was not very dirty and nothing changed when out back together. TPS is fine. I had fiddled with it and made it worse. Took to a mechanic. They did a few things (fan clutch was out, fixed...

Care to share the guide? I found info too. But I put in an aftermarket TPs so it may be giving me readings that aren’t ideal

Hi. Did you ever find out how to properly adjust the TPS?

Hey all. I have a code reading for a faulty camshaft position sensor. This popped up after a tps sensor fault that I replaced. I’m hoping this will be the key to working out the issues I’ve been having, but I just have no idea where this sensor is located. I can’t seem to find any diagram...

would I be able to fit a domestic one on? The amayama cat is crazy expensive

Wondering if anyone can help identify the cause of my noisy Cat. It always had this tinny rattle, but today it seemed quite raucous. Even if it’s a minor problem, I’d love to calm the beast. 1993 l300 4g64

Found this. Hope it helps

Is this throttle stop screw somewhere else on a 4g64 throttle body?

Hey. Yah kinda vague sorry. There is a write up for the diesels that say 1-3 mm or something: Once you get to it you loosen the two nuts on either side. Also can see that rubber boot and if you slide it back there is a metal stopper on the throttle cable. Adjust the position to either side...

Take off the drivers seat and it’s easier to access. Will have to disconnect the parking brake and gas cover lever. But pretty easy after that. The. Just zero out the nut stoppers

Hey. So I’m trying to locate and resolve this sound I’m occasionally hearing. It began after replacing the rear shocks, shackle bushings and rear sway bar bushings with polyurethane ones. It isn’t a constant sound I hear, but does happen often as I’m driving. As far as I can tell it is coming...

Oh dang. Wasn’t there when you opened the hood? Try your hardware store.

Did you figure it out? Almost a year later hah. I think you have to remove the drivers seat and open that panel to access it

Any tips to access this cable on a 4g64?

Did you ever find a fix for this? I seem to be having similar issues, minus the gauges not working

Changed out the air filter a few months ago. I had this issue once before I replaced it. So I can tile it out by not tightening the gas cap all the way?

I’ve been having the occasion startup issue. It happens fairly randomly. Usually after I’ve been driving, stop for a bit, and then start her up again. When I crank it and out my pedal to tue floor it will start. I’m looking for possible diagnosis or fixes. Delica l300 exceed petrol/gasser...

I’m just wondering if the steps for replacing the fuel filter in a petrol version are the same as a diesel. Thanks!

Are the steps similar for a gasser l300?