Yea man! Thanks so much for your support and your review on Etsy
Hey Rossta you can grab it on Etsy or directly with me via venmo @Justin-edmands. Just pm me your address
My passenger door rattles and seems loose at the latch. Do these latches wear out? *Seems* tight-ish and all of the screws are tight for the latch built into the door. All searches I came across were just for the sliding door :/
Any suggestions are appreciated!
Decided to do a run of my cupholder in 3 ply natural Bamboo. Fits nice and snug in the armrest area and the lid closes properly. The provided 3M tape will provide a semi permanent mounting option. You can buy from me directly or use the Etsy link.
$39 plus ship for raw/unsealed
$44 plus ship...
I've been increasing the boost via wastegate adjustments. Mine started around 6 threads on top and 5.5 threads showing on the bottom. I went down to ~3 ish threads top and bottom and only at 11 PSI peak. Shall I keep tightening it to let's say 2, maybe 1 thread top/bottom to hit closer to 14PSI?
Yes not bad -after- you do it the first time. Top two injection pipes loosened from top. Bottom two loosened from bottom.
I had to take photos to remember which ratchet lengths would work for my set / for future tuning.
Confirmed this AM that the spare glow plug brought everything back to normal. After this, I believe I can confirm that it starts and idles smoother after the IP timing advance.
Went through the process of rotating the IP towards the engine a few mm. It's not the best angle in the photo so it may look like 20-30% less adjustment due to that. The top cooling hose is in the way and it's hard to get a non blurry straight shot photo at night. Afraid to add more rotation to...
Out in Colorado. i70 is quite a beast. Always using diesel kleen plus winterizing additive in the winter.
It's great! Only tricky if you have a 5 speed. If you forget about it choked...get ready for high RPMs and a slight freak out :p
Cleaned up the clearances a bit and got it back together. Same thing going on. Removed the EGR valve with a block off kit that I had for a diff van. Mostly I did this due to a recent issue with lack of power/black smoke and I felt like maybe the EGR valve was stuck open. It was intermittent so...