Recent content by Zebruken

I was looking into this exact thing! I bet the rest of the driveline would need upgrading too.

Yes! We come to Portland often perhaps I could just pick it up.

Mine is fairly bent up so I'd like to source another.

Do any of you have insights into the wiring of the flood/fog lights. I have 2 plugs with 3 wires in each. But the Bosch lights on my van only have 2 wires. Were the stock flood/fogs a high/low beam?

Mine was rusted up and won't retract, I tore it apart and it's not salvageable. So, I'm looking for another.

Great idea, I'm doing it now. I'll post their feedback here. Thanks Tom! (Done. Here is the Delica.ca post: http://www.delica.ca/forum/viewtopic.php?f=6&t=18280 )

Drivers floor is getting wet. Both when I am driving and when I am parked. I followed the wetness up above the headlight pod. Thoughts on where to look? Also, any tips on removing any of the front body panels in order to fix any leaks? thanks, Isaac

Inspection panel on bell housing with the drip. Another angle from under the motor looking to the rear of the van Drivers side with the cover removed. You can see oil on the edge of where the plate bolts up. Passengers side with cover removed and same oil spotting. My thoughts are that...

I found this wire coming off the little black "switch". From what I can figure the throttle hits the switch when it is pressed all the way. Anyone know what the wire/switch is for? And where should I plug it back into. thanks, Isaac

...denial! Is your van lifted? I'd like to get rid of the slight rake mine has, get the front even with the rear...like yours!

I did the oil change the other night. All went well, I used 15-40 oil and a Napa 1067 oil filter. The filter screwed on just fine although it was slightly larger in diameter. I now seem to have developed a slight leak by what appears to be an inspection plate on the front of the...

Just north in Chehalis (smack in between you and Seattle)

I'm going to do an oil change today. Potentially silly question, what is the oil capacity of the Delica (including filter replacment)?

Looks fantastic @danderrr ! I'm new here too... I noticed Oregon plates, what part are you from? Welcome!

HEY Portland people...I'm up in Chehalis Washington. So what cars and coffee are we going to show up to this summer in the Portland area?