Search results

Yea man! Thanks so much for your support and your review on Etsy Hey Rossta you can grab it on Etsy or directly with me via venmo @Justin-edmands. Just pm me your address

Sweet! Ordered. They are both in fact warn out

My passenger door rattles and seems loose at the latch. Do these latches wear out? *Seems* tight-ish and all of the screws are tight for the latch built into the door. All searches I came across were just for the sliding door :/ Any suggestions are appreciated!

Bump - 7 left

Decided to do a run of my cupholder in 3 ply natural Bamboo. Fits nice and snug in the armrest area and the lid closes properly. The provided 3M tape will provide a semi permanent mounting option. You can buy from me directly or use the Etsy link. $39 plus ship for raw/unsealed $44 plus ship...

One more vote for the Ace Hardware X121 DC3 $3.99

Hairline crack on far passenger side repaired today. Warranty for life between buyer and company that fixed it.

I've been increasing the boost via wastegate adjustments. Mine started around 6 threads on top and 5.5 threads showing on the bottom. I went down to ~3 ish threads top and bottom and only at 11 PSI peak. Shall I keep tightening it to let's say 2, maybe 1 thread top/bottom to hit closer to 14PSI?

Just completed a 1000 mile trip between UT/CO Price drop

Yes not bad -after- you do it the first time. Top two injection pipes loosened from top. Bottom two loosened from bottom. I had to take photos to remember which ratchet lengths would work for my set / for future tuning.

Confirmed this AM that the spare glow plug brought everything back to normal. After this, I believe I can confirm that it starts and idles smoother after the IP timing advance.

Found one of my newish plugs wasn't working o_Oo_Oo_Oo_Oo_O doh! Swapped over to a spare. Will test cold start early AM

Went through the process of rotating the IP towards the engine a few mm. It's not the best angle in the photo so it may look like 20-30% less adjustment due to that. The top cooling hose is in the way and it's hard to get a non blurry straight shot photo at night. Afraid to add more rotation to...

Out in Colorado. i70 is quite a beast. Always using diesel kleen plus winterizing additive in the winter. It's great! Only tricky if you have a 5 speed. If you forget about it choked...get ready for high RPMs and a slight freak out :p

Cleaned up the clearances a bit and got it back together. Same thing going on. Removed the EGR valve with a block off kit that I had for a diff van. Mostly I did this due to a recent issue with lack of power/black smoke and I felt like maybe the EGR valve was stuck open. It was intermittent so...

Updates: Oct 2023 - Front diff fluid change Oct 2023 - Rear diff fluid change Nov 2023 - Swapped over wheels from a different van with Bridgestone Blizzak winter tires and about 90+ % tread remaining

Going down the rabbit hole of diagnosing the cold starts, but it's an issue with warm starts too. Generally she'll shake for the first 1-2 seconds while starting up, but it runs/drives just fine. Doesnt appear to be too loud and I'll get decent MPG around 22-24 on extended trips. Doesn't feel as...

Price drop. CO title in hand.

Thanks for that!

Year, model 1996 Delica L300 Active World Engine 2.5L Turbo Diesel Transmission Automatic Kilometers: 138,000 (85000 miles) Location: Denver, CO Price: 15,600 Summary of vehicle: This is a recent import from Japan. Purchased in late 2022, then waited for a very long time to get on the boat for...