I just received my FTS Stainless Steel Rack from Taiwan. This baby is SWEEEEET. Forget cheap racks; this is the one to get.
Step one. Unpack your special boxes!
Step Two. Lay out the rack upside down and in an assembled fashion
Step Three. Prepare the linking tubes and fastners. You need to make sure the lock washer goes on the bolt first, followed by the large flat washer.
Step Four. Loosely install linking tubes with fastners. DO NOT TIGHTEN
Step Five. Install Finish plates with the supplied lag bolts. The ones with the 4 relief cuts are designed to go on the inboard side of the rack. The relief cuts are to make room for the linking tube fastners. Fasten but do not tighten.
Step Six.
Prepare the rack legs and fastners. Lock washers on first!
Step one. Unpack your special boxes!
Step Two. Lay out the rack upside down and in an assembled fashion
Step Three. Prepare the linking tubes and fastners. You need to make sure the lock washer goes on the bolt first, followed by the large flat washer.
Step Four. Loosely install linking tubes with fastners. DO NOT TIGHTEN
Step Five. Install Finish plates with the supplied lag bolts. The ones with the 4 relief cuts are designed to go on the inboard side of the rack. The relief cuts are to make room for the linking tube fastners. Fasten but do not tighten.
Step Six.
Prepare the rack legs and fastners. Lock washers on first!
Attachments
Last edited: