Search results

I replaced the two thin protective metal plates with FTS skid plates on my van and have the white bar that goes under the rear bumper. Will trade the bar and original under engine covers for a good 12 pack of beer. Can post pictures later if you’d like. Cheers, Jessey

Recently replaced the upper ball joints on my 91' L300. The upper ball joints are the same part on both sides, I bought mine from Febest on Amazon, part number Mr241623 and they did come with grease point fitting, which I was surprised by. Overall I would say this is a pretty simple task in...

I need to replace the oil line to my vacuum pump, according to Apex Auto and the looks of it. The lower bolt looks easy to access, but I can't see up to see how accessible the upper bolt is. From what I've read on other forums, it looks like I should be able to access it during an oil change...

Jacked up my front end today to replace the upper ball joints. Put jack stands where I believe they should go based on the workshop manuals, but it looks like one side bent in a little bit. Am I completely misunderstanding where to put the jack stands? I have a 91 L300 Super Exceed.

I picked up the hitch and skid plates through a group buy organized by @13mclean. Both are relatively straight forward but neither come with instructions and when I was trying to install over the weekend the FTS website with photos of the install was down so I thought it would be helpful to do a...

My Delica came with a dry rotted spare tire so I replaced it with a 235/75r15 sized tire. When I tried to put it back in the spare tire cage it was too big (width wise) to reattach to the hook. So I decreased the PSI for the time being (I have a portable tire air compressor in the van) until I...

I had been debating between an ARB and a Fiamma F45s awning for a long time, but finally decided on the Fiamma. The main reason was ease of use. I didn't want to be deterred out of laziness from setting it up. I debated using the rain gutters to mount it, but none of the attachments I found...

Hello everyone, I recently purchased a 1991 L300 Super Exceed and have been using this forum and the delica.ca forum as a resource to understand the van and engine better. I've been researching an EGT gauge and likely try to do that soon. Thanks for creating this resource for Delica owners...