Search results

Noooooo! Not the Blue Rhino! It took a drunk with a hard head to dent it... You just can’t make this kind of Sh-t up. Sorry to hear it

Wiper arms?

Added the ARB 2500x2500 awning. Awsome!

Should I keep having it kick in at 58mph to 62mph its where my engine rpm jumps from around 2750rpms to 3500rpms when I’m trying to accelerate ? It’s so annoying and I keep having to back off the gas and reapply gas to get it to speed up past 65mph, a real subtle dance... how do I fix this.

Cool! I hope you liked my video.

What did you deck it with?

I just did a story on my 1994 L300 Chamonix

The pin holds the spring- look at my response prior it shows cutting out a channel in the back side of the seat pivot

Chamonix 94 and I’m including a couple more photos. You need to Chanel out the inside as well as cuting out that chunk of the seat support - there is a stop pin attached to the spring that hits a stop on the inside of the assembly before the seat would even fold flat, so in my view it’s a two...

Works

I just did it - just cut the notch a bit deeper on the plastic piece and it works

Thanks!!!

I’m trying to figure out how to modify the latch so I can fold the passenger front seat forward and flat, I know it must be doable, just need some pointers...

I have nothing but good things to say about Delica USA - they have taken care of anything and everything they said they would, and are responsive to my inquiry’s or warranty issues in my first few months.

Does anybody know how to modify the passenger seat locking mechinism to allow the seat to fold flat forward ??

You da man!!!

I just received my Hyundai bars, but I don’t see any white marks on them, and all the spindle gears are the same size, so why does it matter to line up the non existent white mark on a new fit out?

Order a pair, should be in next week. I’ve never replaced torsion bars before, any good YouTube how too’s?

Initial rear platform using the aluminum square tubes and connectors plus Duraply plywood 3/4” - it should be sturdy enough as is, but if you added any drawers and sliders to it it would firm up even more. I sanded the connectors so they will come apart if I want to remove it or fold it all up...

I am ordering from them- it looks like a great solution and light weight as well. I am going to build out a 3 section interior with 4 lift out and stack panels that when in place create an elevated sleeping area with storage underneath, the idea is a modular design that also is removable if you...