JasonFazioPhotography
Active Member
I have three sets of shields from Taiwan that "fit" an L300. They are smoke grey. I'm asking $265 per pair + actual packaging + actual shipping. The packaging came out to $47 per pair. That turns out to be $312 for a set of Monsoon Shields. Pricey, I know. Sorry.
:-(
Things you should know: (Please read fully before expressing your interest.)
- Neither of the Shields that I have installed fit amazingly. The driver's (RHD) fits best. I've got a small gap in the forward area on each side. The gap on the passenger side is the largest.
I've seen three complete installs of these shields; all of them have these gaps. I decided to drive mine for a few weeks/miles to see how they did before placing the shields up for sale. The gaps have caused me no problems. I have driven in both wind and rain. I 'may' close my gaps with some thick black tape both on the inside and outside. However, I've been driving them like this since April and haven't felt the need to close that gap yet, so they must not be bothering me too badly. See pics.
- The mounting holes are, in my opinion, best guesses as far as optimal location goes and were already in the shields when I got them. I didn't have to edit any of my holes, and the placement was fine. I could see that lengthening the holes might be necessary on some installs as the bracket might sit better if nudged up or down a bit, especiall on holes that aren't already elongated. A dremmel should work. See pics
- I plan to 'edit' the spacing in my actual hardware itself, eventually. I'm going to purchase a few extra washers and tighten a few of my nut/washer/bolt combos. This isn't necessary. I'm just looking to improve upon my install. I may try small rubber washers. This can be a delicate process. Mine don't have any, but I could see stress cracks easily forming around these holes, especially if the mounting hardware is overtightened. See Rio's page for installation instructions linked here:
MONSOON GUARD INSTALLATION - Starwagon.info
This guide will go through the installation process of the Monsoon Rain Guards.
starwagon.info
I installed mine on a warm sunny day in an effort to help coax my shields to the shape I figured I'd be putting them into. I assumed that they'd need to bend a bit. Turns out this likely wasn't necessary, but it made me feel better.
- Note: Be very careful during install. There is no extra hardware. If you drop something and lose it, you'll have to get creative. I used painter's tape as a second set of hands to help me when I did my install.
- Yes, these are pricy; sorry. Trust me, I know. Try paying for five sets and having them shipped from Taiwan to the US.
- Shipping will likely be expensive. Again, my apologies. I got them professionally packaged and, as previously mentioned, I'll only charge you exact shipping and not a penny more. With that being said, I will not be responsible for shipping and/or damages. I've got images of your shields taken during packaging if you are interested.
Reminder: I don't currently know what YOUR shipping rate will be. Ill know that once I get your mailing address. Whatever it is, it'll be added to the price of $265 for the Shields and $47 for the packaging. If the final amount ends up being too much for you, you'll be able to back out. Once you send payment, I'll ship the Shields and there will be no turning back. Please understand. Thanks!
Pictures of my shields being installed as well as your shields being packaged can be found here: https://drive.google.com/drive/folders/1iO6fBNgtCzK_r5LAc4W5t6Jejd4PNdp3 Feel free to choose a particular package while it's available.
If you are in Colorado, or plan to be, I'll gladly try work something out and meet you somewhere and hand deliver them to you if it is more cost effective for you.
Did I miss anything?
