condition: like new
make / manufacturer: Mitsubishi
model name / number: Delica
Delica p35
157417km
Mechanic owned and built for over landing with my daughter ,but with work , life and daughters non interest I would like to sell for someone to enjoy to its potential.
This rig has been completely...
https://www.ebay.com/itm/Indicator-Wiper-Headlight-Switch-L300-Express-Van-86-94-SF-SG-SH-SJ-Column-Stalk/123132153691?hash=item1cab3f8f5b:g:OsQAAOSwoShf9Bxg
You could rebuild yours with a little work and replace the light switch on yours . As much as some of these delica guys insist that...
I guess it depends on the rear end and year yours is . Mits used Dana on some models. I replaced my pads with the mighty max pads and were exact fit. Mine is a 91. Good luck.
It’s pretty basic conversion. Bolts right up, you do have to cut for clearance for high beam to engage if I remember right. I can try to take photos later for you on the trimming on the column covers I did.
You can try stretching the contact springs , I had the same problem and ended up going with a LHD set up due to not liking trying to get used to a RHD set up.
After over a year of owning , finally found time to install. Very simple installation . Only had to do a small trim to clear power steering line. Very stout ! Thanks Evan