Ok, what would that even be called? The clip for securing the speed sensor? I suppose I could probably secure it another way if needed.I would go to pick and pull and pull a spring clip off of the same shape sensor, most likely found on a Mitsubishi or Toyota of similar year.
I would just safety wire it.Thank you. Are you aware of if just that clip can be acquired, or must that whole unit be replaced?
Something like this MIGHT work, but you'd have to get the right size..
IDEC Corporation - SY4S-02F1 - Accessory Hold Down Spring, Used on RH2B, RH3B, RH4B, RY4S, RY42S, RY2LS Series - RS
SY4S-02F1 from IDEC Corporation at RSus.rs-online.com
A friend and I did some research and it seems that several vehicles used this same connector, including the 3000GT. I ended up ordering this, which matches the listed part number. When it arrived, it is slightly different, and although the metal clip is longer overall, it is the proper width. The connector seems secure using this clip. I will update if it fails.Something like this MIGHT work, but you'd have to get the right size..
IDEC Corporation - SY4S-02F1 - Accessory Hold Down Spring, Used on RH2B, RH3B, RH4B, RY4S, RY42S, RY2LS Series - RS
SY4S-02F1 from IDEC Corporation at RSus.rs-online.com
Which plug is that? You have a picture of where the wires went? I can crawl under my van but need to know what you are working withHello there,
I was reading this forum and I need your help, I've been trying to get the information I need but no lucky until now.
A rock damaged my connector and I don't know the order of the wire.
Any help please?