sailmonkeys
Member
Any specs or parts number for exhaust manifold stud bolts and nuts? Thanks
Ask and ye shall receive.Any specs or parts number for exhaust manifold stud bolts and nuts? Thanks
Thanks very much. Coombs Country Autos put on a new cylynder head within the last few years, so I assume the latter size, but I may order both to be on the safe side. I’m fairly motor illiterate though so I’m going to ask what may be a stupid question. Is there a specific length I should be looking for? Any sources that you know of that can ship within the US quickly? I feel like I should be able to find a good supplier in Seattle once I’m up there. Thanks for your time.Studs are 8x20 through 12-91 and 8x25 after.
http://mitsubishi.epc-data.com/deli...e-exhaust/exhaust-manifold/34574,34575,34576/
Simple question: What is the part number in USA for the oil filter? (4D56)
Studs ordered and used were stainless 8x1.25x40ish mmCoombs Countryactually did respond. The specs according to them are 8x1.25 by roughly 40mm. Ordered some and have them on the way.
Taadahhhh!Anyone know if there are rear drum brake shoes available in the US? Part numbers?
I'd prefer to avoid getting ones all the way from Japan or the Middle East.
hey so i was crawling under my van a few minutes ago and noticed the support brace that holds the transmission and the engine, that the rubber has deteriorated. Can anyone give me any details on this?
That might be tough. Might be easier to just measure the bore and the circumference and find a poly replacement.
RHS #MB581261 and LHS #MB581258... ~ $75 ea from Amayama.hey so i was crawling under my van a few minutes ago and noticed the support brace that holds the transmission and the engine, that the rubber has deteriorated. Can anyone give me any details on this?